Supplies
4
¼” X 5 ½” Whisper White Thick Cardstock
4”
X 5 ¼” Designer Series Paper (DSP)
4
¼” X 5 ½” Whisper White Thick Cardstock (Divided as described below)
1
½” X 4 ½” DSP
2
¼” X 4 ½” DSP
2”
X 3” Whisper White Cardstock for image
Scraps
of DSP for punch image and greeting
Memento
black ink
Under
My Umbrella stamp set
Umbrella
Punch
Beautiful
Bouquet stamp set
Exacto
Knife, cutting mat, metal ruler
Coloured
pencils
Scissors
Tear
n Tape
Steps
1.
Attach
4 X 5 ¼” DSP to the 4 ¼ X 5 1/2” Thick Whisper White. This is the base of the card.
2.
Take
the next 4 ¼ X 5 ½” piece of cardstock and place it with the 5 ½” side at the
top of your scoring tool and score at ¼” and 5”. Cut this piece on the short side at 2
½”. You will have 2 flaps. One is 2 ½” C 5 ½” and the other is 1 ¾” X 5
½”. They are scored ½” on one end and ¼”
on the other. Attach DSP to each.
3.
On
the side of each flap that is scored at ¼”, mark a tab and cut away excess
cardstock.
4.
Take
the base of your card and measure 4” from the left side of the cardstock near
the bottom of the base. Then put the
largest flap (2 ½” X 5 ½”) and line it up with the bottom of the base. Slide the flap to the left until you cans see
the 4” mark, then put a dot above and below the tab. Take the flap away and using an exacto knife,
cutting mat and metal ruler, cut a slot between the dots. (Be careful)
Put 2 strips of Tear n Tape on the back side of the ½” scored
section. Line up the bottom of the flap
with the bottom of the card base and fold the ½” section behind the card
base. This attaches the flap to the
base. Mark the tab A and the slot A ( mark where it will not be seen when
assembled)
5.
Make
a mark at 2 ½” from the left side of the large flap. Place the small flap, lined up with the
bottom of the base of the card and the tab on the left side. Slide the flap until you see the 2 ½” mark Place a dot at the top of the tab and at the
bottom. Cut a slit in the large flap
(move the card base away) as before.
Mark this tab and slot B. Put tab A into slot A and tab B into slot B
6.
Using
punches and stamps as desired, decorate your card. What I used is listed
above. I also used Perennial Essence
DSP. I know you’ll come up with
something amazing!his for the word document
